Version 1. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the a It is one of my most pleasant tasks to write this letter to you, because it is the culmination of many months of hard work delivered by our Right from the very start it has been our goal to design a revolutionary unit that can be used for a wide variety of applications. Indeed, this overwhelming power mixer gives

Author:Zuzuru Tozuru
Country:Solomon Islands
Language:English (Spanish)
Published (Last):11 February 2016
PDF File Size:19.25 Mb
ePub File Size:12.96 Mb
Price:Free* [*Free Regsitration Required]

For many years now we have been successful in developing products for studio and live use. Please read the manual carefully and keep it for future reference. Nevertheless, we recommend that you carefully examine the packaging and its contents for any signs of physical damage which may have occurred during transit.

Otherwise, claims for damage or replacement may not be granted. The mains connection is made using the enclosed power cord and a standard IEC receptacle.

For your own safety, never remove or disable the ground conductor from the unit or of the AC power cord. The unit shall always be connected to the mains socket outlet with a protective earthing connection.

Increase the distance between the transmitter and the device and use shielded cables for all connections. Should your country not be listed, please contact the distributor nearest you. Thank you for your cooperation! Thus, you can also connect high-level line signals to the respective channel input.

Never use both at the same time. This rule applies to channels 1 - The mono signal will then be reproduced on both stereo sides. The LED above the switch is lit when phantom power is on.

Please note that the equalizer function also depends on this switch setting see Use it to feed an external monitor amp or active wedge. The signal is taken pre-power amp. Of course, you can also use only the left jack as a mono output. Please make sure that the clip LED lights up with signal peaks only. An appropriate power cord is supplied with the unit. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by fuses of the same type and rating.

Unplug the power cord completely when the unit is not used for prolonged periods of time. For this purpose, switch 21 must be set to its upper position. If, however, you run a mono main mix switch 21 set to its lower position , this loudspeaker output provides the main mix signal in mono.

Please read the information given on the rear panel of your PMP If you do a main mix in mono switch 21 set to its lower position , this loudspeaker output provides the monitor signal in mono.


Please select a division you are interested in:



Behringer PMP3000, PMP5000 User Manual


Related Articles